Zeus Z3 Digital Lock Manual Work

is a multi-access digital lock designed for modern home security, typically used in tandem with the Zeus gate locks to provide a synchronized entrance experience. Access Methods

Open the internal unit's battery cover. Locate the small button next to the batteries. Press it once or twice depending on your exact version firmware to wake the system. The external keypad will illuminate. 2. Setting Master PIN Code Press the Registration button.

| Task | Action / Entry Code | | :--- | :--- | | | Touch the keypad to wake it up. Enter the default master code, followed by # to enter programming mode. The default code is often 123456 or 000000 . You will be prompted to change it immediately for security. | | Change Master Code | Enter Programming Mode → Press 1 → Enter new 6-digit Master Code → Press # → Re-enter new Master Code → Press # . Do not forget this code. | | Add New User (PIN) | Enter Programming Mode → Press 2 → Enter a 2-digit User ID (e.g., 01 ) → Enter a 6-digit User PIN → Press # . | | Add New User (Fingerprint) | Enter Programming Mode → Press 3 → Place your finger on the sensor. You will need to place it multiple times from different angles until the lock indicates success. | | Add New User (RFID Card) | Enter Programming Mode → Press 4 → Tap the RFID card on the sensor area. The lock will beep to confirm it's registered. | | Delete a Specific User | Enter Programming Mode → Press 5 → Enter the 2-digit User ID you wish to delete → Press # . | | Enable/Disable Auto-Lock | Enter Programming Mode → Press 6 → Press 1 to enable (or 0 to disable) → Enter the delay time in seconds (e.g., 015 ) → Press # . | | Volume Adjustment | Enter Programming Mode → Press 7 → Press 1 for High, 2 for Low, or 0 for Mute. | zeus z3 digital lock manual work

This manual provides the technical specifications, sequential programming instructions, configuration options, and troubleshooting workflows required to operate and maintain the lock. Technical Specifications and Hardware Architecture

"Manual work" refers to two distinct actions: Manual Operation (turning knobs) and Manual Programming (setting codes without an app). is a multi-access digital lock designed for modern

Operating the lock manually requires identifying its primary physical interface points across the indoor and outdoor assemblies.

When you are inside and do not want anyone to enter (even with a valid code or card), hold down the Press it once or twice depending on your

Press * # followed by the current (Default is often 123456 ) and # .

supports multiple PIN codes. You can set individual codes for different family members. 3. Daily Operational Manual Work How to interact with the lock on a day-to-day basis: