| Parameter | Display Code | Function | |-----------|--------------|----------| | Start Voltage (Low cutoff) | P1 | When battery voltage drops to this value, relay activates (starts charging). | | Stop Voltage (Full charge) | P2 | When battery voltage rises to this value, relay deactivates (stops charging). |
The 3-pin relay acts as an automated switch. It should be wired in series with one of the charger's or load's output lines to control the circuit. Adjusting Values: buttons to adjust voltage thresholds or timing values.
Sets the voltage threshold where the relay triggers to start/stop based on the mode. Upper Limit Voltage Sets the maximum voltage threshold.
The module features clear screw terminals for power, sensing, and control. Ensure you observe polarity to avoid damaging the unit. 1. Basic Setup Xh-m608 Manual
The Ultimate XH-M608 Manual: How to Configure and Wire Your Battery Charge Control Module
Ensure the battery voltage is at least 6V.
The XH-M608 operates in one of two main modes: or Discharging Mode (P2) . 1. Charging Mode (P1) | Parameter | Display Code | Function |
Ultimate Guide to the XH-M608 Battery Charge Control Module: Manual and Setup
The manual emphasizes several safety precautions to ensure safe operation:
The XH-M608 operates in three distinct modes. Access P1 to choose the function: It should be wired in series with one
The menu dictates the logic governing how the relay reacts to voltage variations. Long-press or short-press SET when highlighting P0 to change its underlying value:
The is a pulse-width modulation (PWM) speed control module designed to regulate the speed of DC motors. It is widely used in industrial settings, DIY electronics, and automation projects due to its ability to control motor speed efficiently without significant power loss.
Users can set specific "Upper Limit" (stop charging/discharging) and "Lower Limit" (start charging/discharging) voltages.