Change the default printer name if using in a shared office.

on the Kidde Global Solutions support site. Note that full installation and programming guides may require a dealer login Product Datasheet

Always turn off the main power supply before handling any electrical wires.

When pressed, this trigger signals the Challenger system to release the door lock temporarily without generating a forced-door alarm. 3. Open Collector Output (Door Strike)

Always turn off the main power supply at the circuit breaker before handling any electrical wiring.

Download or locate the official PDF of the TS1162 installation manual from the manufacturer’s website. Do not rely solely on this guide or any third-party summary.

After configuration, verify the system is working correctly.

Pull the bottom of the body away from the base and lift it off the top tabs.

Have you installed a TS1162 recently? Bookmark this page and download the latest manual from the manufacturer’s portal before your next installation.

: The keypad connects directly to the Challenger RS-485 LAN and can be situated up to from the main panel or Intelligent Access Controller. Addressing : You must use DIP switches 1 through 4 on the unit to set its unique RAS address. Inputs & Outputs : Features a dedicated input for a Request to Exit (RTE) sensor or push-button. Open Collector Output

Check the RS-485 LAN connections and ensure the DIP switch address does not conflict with another device.