The Data Packet With Type-0x96- Returned Was Misformatted

The error SW2275: The data packet with type(0x96) returned was misformatted typically indicates a communication failure or data mismatch during the flashing process. Recommended Troubleshooting Steps :

: The version of the tool being used may not support the specific device or firmware structure.

Capture the communication traffic. Look for packets labeled 0x96 and inspect their structure.

: If you are using version R24.0.0001 and hit error 0x96 , migrate to an authenticated version bundled directly inside the stock factory ROM. If no tool is bundled, look for specialized software options like AMT Tool or SPD Factory Download Tool . 2. Isolate and Clean the USB Connection Layer the data packet with type-0x96- returned was misformatted

Thus, type-0x96 likely refers to a proprietary or application-specific packet. For instance, in a drone telemetry system, 0x96 might mean "GPS coordinate burst"; in a car’s CAN bus, it could mean "Engine coolant temperature".

If you have a log output like this: ERROR: TYPE 0x96 | DATA: FF 00 96 0A 00 08 00 ...

The receiving system has flagged Packet Type 0x96 as "misformatted." This indicates that while the packet was successfully received at the physical layer (cables/connection are working), the data structure did not conform to the expected protocol definition. The receiver could not parse the payload, leading to a rejection of the data. The error SW2275: The data packet with type(0x96)

Since smartphone flashing involves many variables, the exact fix can depend on your specific hardware. If you're trying to fix this and

Follow these solutions in order, starting from the easiest software adjustements to the advanced configuration changes. 1. Match the Tool Version to Your Chipset

: The packet might have been constructed incorrectly by the sender, either due to a bug in the software or a misunderstanding of the protocol specifications. Look for packets labeled 0x96 and inspect their structure

Ensure no other software (like a background syncing app) is trying to "talk" to the same COM port or USB device at the same time.

This indicates a . The system sent a request (or waited for an asynchronous message) of type 0x96 . The remote device (sensor, server, peripheral) responded, but the response violated the expected format. "Misformatted" can mean: