Locate the physical U-shaped ID button/display on the front or rear of the shelf. Press and hold the button until the number blinks.
Check ONTAP alerts; replace module if hardware failure is confirmed. Active link established with upstream/downstream device. SAS Link (In/Out) No physical connection or link partner detected.
Squeeze the cam handle release latch and swing the handle downward to unseat the module. Slide the PSU out of the chassis. Netapp Naj-1501 Manual
Always wear a properly grounded antistatic wrist strap connected to an unpainted surface of the rack chassis before touching internal components or drive carriers.
Watch the LEDs transition to green. In ONTAP, run storage shelf show -errors to verify the shelf has returned to an optimal state. Common Issues and Resolutions Issue: ONTAP reports "Single-Path HA" or missing paths. Locate the physical U-shaped ID button/display on the
Align the module with the chassis tracks and slide it inward smoothly until you meet resistance.
Use this reference table to quickly decode the behavior of the diagnostic LEDs found on the front control panel and rear interface modules of the NAJ-1501. Component LED Required Action Solid Amber System fault detected Active link established with upstream/downstream device
To ensure the longevity and reliability of the NAJ-1501, it must be operated within specific environmental parameters.
Reattach the data cables to their exact original positions.
Compatible with AFF (All-Flash FAS) and FAS controllers running ONTAP. Drive Support: 2.5-inch SAS SSDs and SAS HDDs. Connectivity: 12Gb/s SAS (IOM12 modules). Power Efficiency: Dual hot-plug PSUs. Accessing the Full NetApp NAJ-1501 Manual