| Error Code | Meaning | Verified Fix | |------------|---------|----------------| | | Reverse polarity | Swap the clamps (positive to positive, negative to negative). | | E02 | Bad battery connection | Clean terminals and reconnect firmly. | | E03 | Battery voltage too low (<3V) | Charge with another charger at 2A for 15 minutes to bring voltage up. | | E04 | Short circuit in battery cell | Battery is dead—replace it. (Verifies with a voltage drop test over 1 hour.) | | E05 | Internal temperature >65°C | Unplug and cool for 30 minutes. Verify fan is spinning. | | E06 | 40A boost timeout exceeded | 40A mode auto-shuts off after 5 seconds if engine doesn't start. Wait 2 minutes and retry. |
Following the correct sequence is critical for safety and battery health. Preparation
: Features microprocessor-controlled multi-stage charging that switches to Maintain Mode automatically. Operating Instructions Preparation
: Plug the charger into a grounded 120V AC outlet. The charger typically begins detecting the battery within 5 seconds.
Elias grabbed a screwdriver. He removed the faceplate screws and pulled the assembly out. Sure enough, the mechanism was gummed up with decades of old grease that had turned into a glue-like paste. The plastic cam was slightly misaligned. motomaster battery charger 111567 manual verified
While this charger is safe for Standard and Maintenance-Free batteries, users with or Gel Cell batteries should ensure they do not use the "Fast Charge" (40A) setting aggressively, as these battery types are sensitive to voltage spikes. The 10A setting is generally recommended for AGM/Gel batteries to prevent overheating.
Buzz.
Select your desired charge rate (2A or 10A) using the toggle switch.
Always verify your unit’s exact revision – early 111567 units used an analog meter; later revisions had a digital display. | Error Code | Meaning | Verified Fix
Connect the clamp to the positive (+) battery post.
: Ensure the area is well-ventilated. If you must remove the battery from the vehicle, always disconnect the grounded (negative) terminal first to prevent arcing. Connections Connect the Red (Positive +) clamp to the positive battery post. Connect the Black (Negative -)
: Shows voltage, charge rate, and charging status (e.g., "FUL" when complete). Engine Start Mode
If charging a removable-cap battery, top up individual cells with distilled water to the manufacturer's specified line. | | E04 | Short circuit in battery
Understanding the interface ensures you choose the correct settings for your specific battery type and condition. Current (Amp) Selection
Internal cell damage, heavy sulfation, or the battery voltage is too low (often below 2V) for the charger to recognize it.
The (often labeled as the "Automatic 6V/12V 2/10/55A Battery Charger and Engine Starter" ) is a heavy-duty, wheeled unit sold primarily through Canadian Tire. It is designed for both professional and home garage use, capable of charging standard, AGM, and deep-cycle batteries, as well as providing engine start assistance.
For a complete digital copy, you can view verified manuals on Scribd or the MotoMaster Device Database.