Except for one byte at offset 0x1F4. Value: 0x01.
Batch mode support enables automated, high-volume programming in manufacturing environments.
Download from the Infineon Developer Center and run the installer (usually setup.exe or IMT4.exe ) with administrator rights . infineon memtool 4.9
flash sections from unauthorized access or overwrites. Key Features of Version 4.9
: Primarily uses Intel-Hex-Files for writing content to the target device. Except for one byte at offset 0x1F4
Which (e.g., miniWiggler, onboard DAP) are you using?
| Problem | Likely Cause | Solution | |---|---|---| | Memtool cannot connect to device | IDE using DAS port | Close all IDEs (ADS/TASKING/HIGHTEC) before launching Memtool | | Initialization error on startup | Incorrect target chip configuration | Click "ignore", then select Target → Change → choose correct configuration | | "Not ready" error for certain memory areas | UCB or other memory not enabled | Select the memory area and check "Enable" before programming | | BSL communication fails | Wrong COM port selected | Go to Target → Setup and verify COM port setting | | Device not detected by DAS Scanner | Physical connection issue | Check cable connections, power supply, and HWCFG pin settings for Bootstrap mode | | Installation blocked | Antivirus interference | Temporarily disable antivirus before installation | Download from the Infineon Developer Center and run
Memtool 4.9 is not intended for debugging, real-time variable monitoring, or support for modern AURIX™ TC2xx/TC3xx devices. It also lacks native integration with Eclipse-based environments and may struggle with Windows 10/11 driver signatures for older parallel port or LPT dongles.