To avoid wasted time, gather the following items before you begin your Gpsui.net setup:
Secure the target IP address and designated port number corresponding to your specific hardware protocol. 2. Configuring the GPS Tracking Device
: For remote tracking, a SIM card with an active data plan and disabled PIN lock is required. 2. Initializing the GPSUI.NET Library
Your tracker needs to know how to access your cellular network's internet data. Refer to your mobile carrier's documentation for the exact APN name.
Input the vehicle identification number (VIN), license plate, asset name, and driver assignment. Gpsui.net Setup
Draw virtual boundaries on the map. Receive instant alerts if a vehicle enters or exits these designated zones.
Check if the SIM has an active data balance. Test the SIM in a smartphone to ensure it can browse the web without a PIN lock.
This is the most critical step. Your tracker must know the of your SIM card provider to send data to Gpsui.net.
Setting up Gpsui.net is a straightforward process that requires some basic technical knowledge and attention to detail. Here's a step-by-step guide on how to set up Gpsui.net: To avoid wasted time, gather the following items
Receive alerts when devices enter or leave designated areas.
Re-send the APN SMS command using the exact network parameters. Tracker has not acquired a GPS satellite fix yet.
Once you've completed the setup process, test your Gpsui.net setup to ensure everything is working correctly. Log in to your account and verify that your device is reporting location data and that the tracking features are working as expected.
Choose a shape geometry: , Circle , or Route Corridor . Input the vehicle identification number (VIN)
The first and most critical step is inserting the SIM card correctly. Many users struggle with this because the SIM slot in these compact trackers is tight, and the card is easy to misalign.
: Some network providers require you to manually set the APN (Access Point Name) for GPRS data to work. Tracking Interval
The first step in any implementation is adding the library to your project and initializing the core services.