Cwfl-6000 Manual Jun 2026

If you are installing this in a region with cold winters, read the section on "Low Temperature Startup" carefully—starting the compressor immediately in freezing temps can damage the compressor. Allow the unit to warm up or use the built-in heater function first.

Its rugged design is validated by international safety and quality standards, including , and an SGS-certified version (equivalent to UL standards) is also available, verifying its reliability for industrial use worldwide.

Clean the condenser fins using compressed air. Do not use high-pressure water. 3. Cleaning the Filter cwfl-6000 manual

Locate the water level gauge on the back or side of the unit. Slowly pour water into the fill port.

Maintain at least 50cm between the air outlets (back/sides) and obstacles to prevent overheating. If you are installing this in a region

This comprehensive manual guide covers everything you need to know to install, operate, and troubleshoot your CWFL-6000 chiller effectively. 1. Technical Specifications Overview

One of the most valuable sections of the covers remote communication. Your chiller can talk to your laser controller via RS485 using Modbus RTU protocol. This allows the laser to auto-shutdown if the chiller fails. Clean the condenser fins using compressed air

Connects to the fiber laser source.

Toggle the "POWER" switch to turn the unit on. The pump will start operating. Check the water pressure gauges. Temperature Control Modes