Bosch Serie 6 Service Mode Direct

Use the (left or right arrows) to scroll through the primary menus.

[Off Position] ──> [Rotate to 6 O'Clock] ──> [Hold RPM Button] ──> [Rotate to 7 O'Clock] ──> [Release Button] 📊 Navigating the Service Program Codes (P01 to P30)

Dryers use a different sequence to enter the technician menu for maintenance tasks like manual cleaning cycles.

While holding the button, turn the program selector dial one click further clockwise to the 7 o'clock position (typically the Delicates or Wool cycle).

Turn the program selector dial to the position (12 o'clock). Wait 5 seconds for the control board to discharge. Step 2: The Key Combination bosch serie 6 service mode

The dishwasher service mode is primarily used to run a "Short Test Cycle" to verify pump, heater, and sensor functionality.

| Code | Function | |------|-----------| | T0 | Exit / reset | | T1 | Door lock test | | T2 | Water inlet valve | | T3 | Drain pump | | T4 | Drum motor low speed | | T5 | Heater & temperature sensor | | T6 | Tachometer / rotation feedback | | T7 | Display & button test |

: While inside the P01 error code history log, press and hold the Start/Pause button for roughly five seconds. The display will alter to indicate clearing or show a series of horizontal lines.

For Bosch Serie 6 induction and electric hobs, there is no "self-test" program in the same sense. However, you can access a that provides product information and lets you adjust parameters. Use the (left or right arrows) to scroll

Service mode is typically used to identify stored error codes. : Ensure the unit is off and no lights are on.

Press and hold the button while turning the dial one click clockwise, then release.

For Bosch Serie 6 hobs, the menu (not a full service mode) can be accessed as follows:

: Ensure the appliance dial points to the Off position. Close the door completely. Turn the program selector dial to the position (12 o'clock)

✅ :

Service Mode is a built-in firmware feature that bypasses standard program controls. Instead of running a wash or dry cycle, the appliance enters a state where sensors, heaters, pumps, motors, and valves can be activated individually. This helps pinpoint faulty parts without running a full cycle.

Checks internal grounding and control board integrity.