Connect the clamps to the battery/ground as outlined in Step 2. Plug the charger into the AC outlet.
Lead-acid batteries generate explosive hydrogen gas during normal charging. Never operate the charger in a closed, unventilated space.
60 Amp setting for rapid energy restoration.
The Autocraft Battery Charger AC-60CR is a reliable and efficient solution for charging 12-volt lead-acid batteries. By following the guidelines outlined in this manual, you can ensure safe and effective operation of your charger. If you have any questions or concerns, please don’t hesitate to contact our support team.
Clean the copper jaws of the clamps after every use. Wipe away any leaked battery acid with a solution of baking soda and water to prevent corrosion.
Attach the BLACK (Negative/-) clamp to a heavy, unpainted metal part of the engine block or vehicle frame. Never attach the clamp to the carburetor, fuel lines, or sheet-metal body parts.
: Displays the current drawn from the charger in real-time. As a battery reaches full charge, the needle should move toward 0A. Engine Start
Understanding your tool’s capabilities prevents equipment damage and ensures efficient charging cycles.
The analog meter on the front panel indicates the amount of current (measured in amps) that the battery is drawing from the charger.
If the battery is not sealed, add distilled water to each cell until the acid level reaches the manufacturer's specified level.
Hours to Charge=Battery Amp-Hour (Ah) RatingCharger Setting (Amps)×1.25Hours to Charge equals the fraction with numerator Battery Amp-Hour (Ah) Rating and denominator Charger Setting (Amps) end-fraction cross 1.25
© 2026 SureSwift Capital, Inc. All rights reserved.
