Altendorf - F90 Manual |link|

The manual didn't start with "Plug it in." It started with the . Elias followed the diagrams, adjusting the eccentric rollers until the ten-foot carriage glided with a ghostly silence. According to the manual, a properly tuned F90 carriage shouldn't just move; it should float . 2. The Heart of the Machine

Check the tension of the drive belts inside the motor compartment. Deflection should be minimal when pressed with a thumb. Replace worn or cracked belts in matched pairs. Monthly Maintenance altendorf f90 manual

Always engage the scoring blade when cutting veneered panels or melamine. This not only yields a cleaner cut but prevents dangerous kickback caused by material pinching. The manual didn't start with "Plug it in

The sliding table must move perfectly parallel to the main saw blade. Mount a stable, flat board on the sliding table. Make a skim cut along the edge. Replace worn or cracked belts in matched pairs

Run at higher speeds (5000–6000 RPM). Using the Scoring Unit

Apply a light lithium grease to the height adjustment lead screws and gears.

: Integrated unit used to prevent breakout on the underside of laminated boards. Drive System